Is your Kobold VK7 displaying an error code between 80 and 98 or code 144? These codes usually relate to the connected accessories or internal system configurations. In most cases, simply removing the battery for one minute is sufficient. For codes 80 to 83, additionally check the contacts on the attachment for dirt and ensure that the accessory is properly snapped into place.
Overview of Error Codes
- Code 80–83 – Attachment Errors: Remove the battery for one minute, check contacts, test with another electrical attachment if necessary.
- Code 84 – System Information: Not an error – just a status message from the system.
- Code 96, 97, 98 – Internal Configuration Error: Disconnect the VK7 battery from the device for one minute.
- Code 144 – System Reset Required: Remove the battery for one minute to reset the system.
Procedure for Recurring Errors
- Remove the VK7 battery and wait one minute.
- Detach the attachment and clean the contacts with a dry cloth.
- Snap the attachment back in place and insert the battery.
- If the error persists, test using a different attachment.
Important Notes
- Code 84 is not an error and requires no action.
- Always snap attachments in fully until an audible click is heard.
- Clean contacts only with a dry, lint-free cloth – do not use liquids.