Thermomix® - Fixing Error Code 56

Introduction

Error code 56 on the Thermomix® indicates a problem with the motor control or speed regulation. This error occurs when the device cannot reach or maintain the desired speed. In this article, you will learn the causes of error code 56 and how to fix the problem yourself.

Prerequisites

• Thermomix® is disconnected from the power supply
• Device is completely cooled down
• Mixing bowl and blades are accessible

Causes and Solutions

Problem: Error code 56 appears when starting

Cause: The mixing bowl is overloaded or the ingredients are blocking the blades.

Solution:

1. Disconnect the device from the power supply – the device is completely turned off
2. Remove the mixing bowl and check the fill level – the maximum fill level of 2.2 liters must not be exceeded
3. Check if ingredients are blocking the blades – the blades must be able to rotate freely
4. Reduce the amount or chop large pieces – smaller portions enable better processing
5. Reinsert the mixing bowl and restart the device – the error code should no longer appear

Problem: Error code 56 during operation

Cause: The blades are dirty or the blade holder is blocked.

Solution:

1. Turn off the device and disconnect it from the power supply – the device is completely turned off
2. Remove the mixing bowl and take out the blades – the blades can be loosened by turning counterclockwise
3. Clean the blades and blade holder thoroughly – all residues must be removed
4. Check the blade holder for damage – the holder must be intact and move freely
5. Reinsert the blades and start the device – error code 56 should be resolved

Problem: Error code 56 despite correct loading

Cause: The motor control or an internal sensor is defective.

Solution:

1. Perform a reset: Disconnect the device from the power supply for 2 minutes – all temporary errors will be reset
2. Reconnect the device and start a test run without ingredients – the device should run without errors
3. If error code 56 still appears, contact Vorwerk customer service – professional repair is required

Result

After successful troubleshooting, your Thermomix® will start without error code 56 and reach the desired speed. The device will operate normally again, and you can use all functions.

Notes & Troubleshooting

Important: Never attempt to open the device or repair internal components yourself. This will void the warranty and can be dangerous.

Note: If error code 56 occurs frequently, this may indicate motor overload. Reduce the fill level and avoid very hard or frozen ingredients in large quantities.

Related Articles

• Thermomix® Error Codes – Overview and Meaning
• Cleaning and Maintaining Blades – Thermomix®
• Properly Filling the Mixing Bowl – Thermomix®
• Contacting Customer Service – Vorwerk Switzerland